Author Topic: Ethernet NV Memory IP doesn't seem to load  (Read 2945 times)


  • Newbie
  • *
  • Posts: 1
    • View Profile
Ethernet NV Memory IP doesn't seem to load
« on: June 12, 2011, 06:54:15 »
Config says I have the DIP switch settings right, but it's not loading the IP from NV mem.  I always get when I power up, even if I've changed it.  If I change the IP in the dialog and say 'use now' it works (comes up in the browser with the IP I just entered) . And I can store the IP address in NV mem and it appears in the lower part of the Ethernet dialog.  It just never uses the IP I entered on power up ... it's stuck on .

Has anyone else had this problem?


  • Administrator
  • Jr. Member
  • *****
  • Posts: 49
    • View Profile
Re: Ethernet NV Memory IP doesn't seem to load
« Reply #1 on: June 12, 2011, 18:27:58 »
Hi James,
Just tested one and it seems to work OK.
- if SW1 is off and SW2 is on - reboot board and it will be fixed IP address
- use web browser to verify you can access the board and get status web page.
- use Config Program_Ethernet Options and change the the IP to and click the check box to write address to NV memory. Exit Config propram or use menu option Device Close.
- change SW1 to on and SW2 to off. Power cycle the board or short the reset header J2.
- Restart Config Program and it should show new IP and a browser should now find status web page at