« Last post by Admin on February 01, 2014, 14:15:33 »
There is not a driver on the CD. The USB Watchdog device uses the built in Windows HID driver. Other devices also use the HID driver such as a keyboard, mouse, game controller, etc. Can you try removing these devices one by one and see if any of them are interfering,
« Last post by Admin on December 26, 2013, 14:25:56 »
Very sorry for the late reply. Your post was overlooked.
Can you check Device Manager and see if an HID device is being installed each time you plug in the watchdog. Under properties it should Device & VID of: 0C98 1140. Do you get the successful acknowledgement beep when you plug in the card?
« Last post by fanboi on October 12, 2013, 14:03:30 »
From looking at the Universal DLL PC Watchdog Programmer's Guide, it appears that the WD_GetTempTickle function is what I need to call to reset the timer. Is this true? I am a bit confused because it also reads the temperature. I am not concerned about the temperature.
Is this just a case of a function doing two different things? Or, is there another (non temperature-related) function I need to use?
« Last post by nkent01 on October 10, 2013, 03:57:32 »
I found the problem! Used the contact spray on the dip switches and toggled them several times. Now the watchdog seems to work as expected. So I think it was some dust or oxide build up preventing SW5 from turning off. Thanks